Music fountain project is a very representative net red project in landscape engineering. So what aspects should we pay attention to in the process of acceptance after the completion of the fountain project? Today, Zhu Gong, a professional music fountain manufacturer, has sorted out some specifications that need attention when accepting and accepting projects for your reference.
Firstly, whether the pump under the pool of the music fountain project is firmly installed involves the service life of the pump in the later period.
Secondly, whether the water pipes on the bottom surface of the engineering pool are soldered firmly to prevent leakage and support the stable water pressure of the fountain in the later stage.
Thirdly, check whether the agreement has been reached according to the detailed business area before the cooperation.
Fourthly, check whether the fittings of the water supply and transportation system are complete and not leaking.
第一：预制及加工主要工艺流程 A、预制管道：放样画线→切割下料→钢管变曲→主管打孔→立管套丝→泵口加工→焊接立管→焊接法兰→一次清洗→二次镀锌→ 运往施工现场。 B、喷头加工：熔铜→铸造→车床车削→抛光处理→防腐处理→ 合格入库。 C、控制设备：元件检测→线路板焊接→整板调试→组件安装→ 整机调试→老化试验→合格入库。 D、配电设备：机箱加工→电气设备安装与连线→合格出厂。
Installation Specification for Fountain Engineering:
Main technological process of fountain engineering:
First: Prefabrication and processing of the main process A, prefabricated pipelines: laying out lines cutting and cutting materials pipe bending main perforation riser sleeve pump mouth processing welding riser welding flange one cleaning Secondary galvanizing shipment to the construction site. B. Sprinkler processing: molten copper casting lathe turning polishing anticorrosion qualified storage. C. Control equipment: component testing circuit board welding whole board debugging assembly installation whole machine debugging aging test qualified storage. D. Distribution equipment: case processing electrical equipment installation and connection qualified factory.
Preparations for commissioning of fountain engineering system
1. Clean the pool and inject the water into the normal water level.
2. Cleaning the housings and cabinets of indoor sanitation and cleaning equipment in the machine room;
3. Drying electrical equipment;
4. Check whether the system process installation is correct.
5. Single-machine test run of electrical equipment.
Because the installation of fountain equipment needs to be carried out on the construction site and is open-air operation, the pre-fabrication of pipelines, electrical and underwater lamps should be adopted in advance when conditions permit, which is the key to ensure the progress of the project and the quality of the project.
For the whole fountain project, the standard of inspection is the last line of defense for quality. Many hidden quality hazards are caused by the failure of acceptance units to operate in accordance with the inspection norms. At this time, we need to focus on every link of the project and deepen the inspection and acceptance system. A good project must stand up to the requirements of high accuracy.